For those of you with S13 and really lame coilovers that are not full tap, like Tein HR or Really fantastic coilovers with fancy helper springs like Ohlins, I present to you MAX RUCA IV.
This next version shown in these test fit photos has more room on the inside of the revised bend to work with more coilovers out there.
Release date is unknown, but since tests were successful, we will proceed with manufacturing for sure.
Special thanks to Mr. Ever Reve for the testing.
Version III with Tein HR - Hits when you try to lower it all the way: Version IV with Tein HR - Clears when spring is fully lowered: Comparison shots:
Pic looks like S14 coilovers, there is never been an issue with any S14 type only S13, anyhow if that design was on an s13 it should be fine. We do have a cable holder, it bolts on, although its just not bolted on in most of our photos. Also you may not need it at all if your brake line does not touch anything when steering left and right. I've never needed them on my car.
RUCA IV in stock now. We are no longer seling version 3...Check it out!
More clearence inside so they are able to fit all styles of coilovers Forged one piece rod end Quality TIG welds Swept up to clear the axle boot on super low cars
